HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

Configuring the switch
150
Table 98 Simple Network Management Protocol (SNMP) controls
Control Description
SNMP state machine timeout (1-30 minutes) Sets the timeout value for the SNMP state machine.
Send SNMP Auth. Failure Traps? Enables or disables the use of the system authentication trap facility.
The default setting is disabled.
Switch Management Processor Configuration buttons
The following table describes the Switch Management Processor Configuration buttons:
Table 99 Switch Management Processor Configuration buttons
Control Description
Submit Sends this form to the switch. Any configuration changes are placed in the “pending”
state and do not take effect until the toolbar Apply command is given.
Diff Shows any pending configuration changes.
Diff Flash Compares new configuration with the flash configuration.
Revert
Removes pending configuration changes between apply commands. Use this
command to restore configuration parameters set since last apply command.
Revert Apply
Removes pending configuration changes between save commands. Use this command
to restore configuration parameters set since last save command.