HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

Configuring the switch
158
NTP Configuration
To display the following form, select System > NTP.
This form enables you to synchronize the switch clock to a Network Time Protocol (NTP) server. By
default, this option is disabled.
The following table describes NTP Configuration controls:
Table 103 NTP Configuration controls
Control Description
NTP Server IP Address Configures the IP address of the primary NTP server to which you want to
synchronize the switch clock.
Transfer Port of Primary Server Configures the type of port used for data transfers between the switch and the
primary NTP server.
Secondary NTP Server IP Address Configures the IP address of the secondary NTP server to which you want to
synchronize the switch clock.
Transfer Port of Secondary Server Configures the type of port used for data transfers between the switch and the
secondary NTP server.
Resync Interval (1-44640) Specifies the interval, that is, how often, in minutes (1-44640), to re-
synchronize the switch clock with the NTP server.
Enable/Disable NTP Service Enables or disables the NTP synchronization service.