HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

Configuring the switch
163
Table 105 Switch Image and Configuration Management controls
Control Description
Next Boot Image Selection
Selects which software image (image1 or image2) you want to run in
switch memory for the next reboot.
Active Configuration Block Displays the Configuration Block file that is currently running (active or
backup).
Next Boot Configuration Block Selection Selects the Configuration Block file (active or backup) that will run after
the next reboot.
Next CLI Boot Mode Selection Selects the type of command-line interface (CLI) used after the next
reboot.
FTP/TFTP Settings
Hostname or IP Address of TFTP server Enter the host name or IP address of the TFPT server from which you
will download software.
Username for FTP Server or Blank for TFTP
Server
Enter the user name, if you are using a FTP server.
Password for FTP Server Enter the password for FTP server.
Port for Transfer Select the port type to use for the file transfer (management port or
data port).
Image Settings
Image for Transfer Selects a software image to replace with the downloaded software.
Image Filename (on server) Enter the name of the file on a TFTP server that contains the software
image you want to download.
Image Filename (on HTTP Client) Enter the name of the file on an HTTP Client that contains the software
image you want to download.
Config/Dump Settings
Configuration Filename Selects the file name and location of the Configuration Block file to be
downloaded.
TS Dump Filename Selects the filename for the TS (tech support) dump that you want to
upload to the TFTP server.
Flash Dump Filename Selects the filename for the core (PANIC) dump that you want to
upload to the TFTP server.
Status of Previous Transfer Displays the status of the previous software download attempt.