Manualshelf

HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

ManualsBrandsHP ManualsComputer AccessoriesHP 10Gb Ethernet Blade Switch for c-Class BladeSystem
161162163164165166167168169170
Configuring the switch
164
Switch Image and Configuration Management buttons
The following table describes Switch Image and Configuration Management buttons:
Table 106 Switch Image and Configuration Management buttons
Button Description
Get Image Starts download of the software image file indicated in TFTP Image Filename field from the
specified TFTP server.
Put Image Starts upload of the software image file indicated in TFTP Image Filename field from the
specified TFTP server.
Get Config Downloads a previously saved switch Configuration Block file indicated in Configuration
Filename from the specified the TFTP server.
The active configuration will be replaced with the commands found in the downloaded
configuration file. The file can contain a full switch configuration or a partial switch
configuration.
The new configuration is not activated until the apply command is used. If the apply
command is found in the configuration script file loaded using this command, the apply
action is performed automatically.
Put Config Uploads the switch’s active configuration to the script configuration file specified in
Configuration Filename. The file is placed on the TFTP server.
Put TS Dump Uploads the TS (tech support) dump file to the TFTP server specified in TSTP TS Dump
Filename.
Put Dump Uploads the core (PANIC) dump file to the TFTP server specified in Core Dump Filename.
Clear Flash Dump Deletes the core dump in flash memory.
Submit When selected, the form is sent to the switch. Any configuration changes are placed in the
“pending” state and do not take effect until the toolbar Apply command is given.
REBOOT! Reboots the switch.
NOTE: If the TFTP server is running SunOS or the Solaris operating system, the specified Put Config
file must exist prior to executing the Put Config command and must be writable (set with proper
permission, and not locked by any application). The contents of the specified file will be replaced
with the current configuration data.