HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

Configuring the switch
168
Table 108 Switch Port Configuration controls
Control Description
PVID Tagging Disables or enables VLAN tag persistence. When disabled, the VLAN
tag is removed from packets whose VLAN tag matches the port PVID. The
default value is enabled.
Port STP Turns Spanning Tree On or Off for this port.
Default Port VLAN ID (1-4094) Sets the default VLAN number which will be used to forward frames
which are not VLAN tagged.
The default number is 1.
NOTE: VLAN 4095 is reserved for switch management.
Flow Control Sets the flow control. The choices include:
• Receive flow control
• Transmit flow control
• Both receive and transmit flow control (default)
• No flow control
Autonegotiation Enables or disables auto-negotiation for the port.
NOTE: All downlink and uplink ports are fixed at 10000 Mbps, and
cannot be set to auto-negotiate.
Speed Sets the link speed.
NOTE: All downlink and uplink ports are fixed at 10000 Mbps, and
cannot be changed. Management port 17 is fixed at 100 Mbps.
Duplex mode Sets the operating mode, as follows:
• Full-duplex
NOTE: All ports are fixed at full duplex, and cannot be changed.
Enable/Disable sending Link UP/Down
Trap
Enables or disables the sending of SNMP link up and link down traps.
The default setting is enabled.
Port Name Sets a name for the port. The assigned port name appears next to the
port number on some information and statistics screens.
Multicast Threshold Enables or disables multicast threshold limit.
Limits the number of multicast packets to the specified value. If disabled
(dis), the port forwards all multicast packets.
Multicast Threshold Rate (0-262143) Configures the threshold rate for multicast packets, in packets per
second.
Broadcast Threshold Enables or disables broadcast threshold limit.
Limits the number of broadcast packets to the specified value. If disabled
(dis), the port forwards all broadcast packets.
Broadcast Threshold Rate (0-262143) Configures the threshold rate for broadcast packets, in packets per
second.
Destination Look Up Fail Threshold Enables or disables threshold limit for destination lookup failures.
Limits the number of unknown unicast packets to the specified value. If
disabled (dis), the port forwards all unknown unicast packets.