HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

Configuring the switch
175
Table 113 Port 802.1x Configuration controls
Control Description
Server Timeout (0-65535 sec) Sets the time, in seconds, the authenticator waits for a response from the
Radius server before declaring an authentication timeout. The default value is
30 seconds.
The time interval between transmissions of the RADIUS Access-Request packet
containing the supplicant’s (client’s) EAP-Response packet is determined by the
current setting of /cfg/sys/radius/timeout (default is 3 seconds).
ReAuth Status Sets the re-authentication status to on or off. The default value is off.
ReAuth Period (1-604800 sec) Sets the time, in seconds, the authenticator waits before re-authenticating a
supplicant (client) when periodic re-authentication is enabled. The default
value is 3600 seconds.
Overwrite Configuration with Overwrites the port configuration settings with the global or default 802.1x
settings.
FDB Configuration
To display the following form, select Layer 2 > FDB (click the underlined text, not the folder).
The following table describes the FDB Configuration controls:
Table 114 FDB Configuration controls
Control Description
Bridge Aging Time
(0-65535 secs)
Configures the forwarding database aging time. The aging time specifies the amount of time
the STP bridge waits without receiving a packet from a station before removing the station
from the forwarding database. The default value is 300 seconds.
To disable FDB aging, set the value to 0.