HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

Configuring the switch
236
Table 162 RIP Interface Configuration controls
Control Descriptions
Triggered Updates? Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send update
messages immediately, even if it is not yet time for the update message. The default
value is disabled.
Multicast Updates? Enables or disables multicast updates of the routing table (using address
224.0.0.9). The default value is disabled.
Split Horizon? Enables or disables split horizon. The default value is enabled.
RIP Metric (1-15) Configures the route metric, which indicates the relative distance to the destination.
The default value is 1.
Authentication Type Configures the authentication type. The default is none.
Authentication Key Configures the authentication key password.
RIP Route Redistribution Configuration
To display the following form, select Layer 3 > Routing Information Protocol > Static Route
Redistribution, Fixed Route Redistribution, OSPF Route Redistribution, or OSPF External
Route Redistribution.