HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

Configuring the switch
243
VRRP General Configuration
To display the following form, select Layer 3 > Virtual Router Redundancy Protocol > General.
The following table describes the VRRP General Configuration controls:
Table 169 VRRP General Configuration controls
Control Descriptions
VRRP Processing Enabled? Globally enables or disables VRRP processing.
VRRP virtual router tracking
increment (0-254)
Defines the priority increment value (1 through 254) for virtual routers in master
mode detected on this switch. The default value is 2.
VRRP IP interface tracking
increment (0-254)
Defines the priority increment value (1 through 254) for active IP interfaces
detected on this switch. The default value is 2.
VRRP VLAN switch port
tracking increment (0-254)
Defines the priority increment value (1 through 254) for active ports on the virtual
router’s VLAN. The default value is 2.
VRRP Virtual Router
Group Configuration
Virtual Router Identifier (1-250) Assigns a numeric identifier to the virtual router group.
IP interface (1-249) Defines the IP interface associated with the virtual router group.
Enabled? Enables or disables the virtual router group.