HP 10Gb Ethernet BL-c Switch Browser-based Interface Reference Guide

Configuring the switch
246
Bootstrap Protocol Relay Configuration
To display the following form, select Layer 3 > Bootstrap Protocol Relay.
The following table describes the Bootstrap Protocol Relay configuration controls:
Table 171 Bootstrap Protocol Relay Configuration controls
Control Description
BOOTP Server IP Address Sets the IP address of the BOOTP server.
Secondary BOOTP Server
IP Address
Sets the IP address of the secondary BOOTP server.
BOOTP State Enables or disables the use of BOOTP. If you enable BOOTP, the switch will query its
BOOTP server for all of the switch IP parameters. The default value is enabled.
IP Routing General Configuration
To display the following form, select Layer 3 > General.