HP 10Gb Ethernet BL-c Switch User Guide

Performing a serial download 40
8.
Select <Transfer-Send File> from the menu and choose these options in the Send File window:
The Send File window displays progress of the file transfer. The file transfer might take up to seven
minutes.
NOTE: Although slower, XModem also works if 1K MODEM is not used.
9. After completing the transfer, a message displays how many bytes transferred, followed by another
message displaying the status of image extraction. Do not power cycle the switch during this
process. After extracting the image, it is updated to flash and a message with a progress indicator
displays as shown.
CAUTION: Do not power off the switch until the message: "Change your baud rate to 9600
bps and power cycle the switch," is displayed, otherwise, the switch will be inoperable.
10. Change the baud rate to 9600 and power off the switch, wait for a few seconds, and power on the
switch.
The switch boots with the new version of the boot code image that was just downloaded.
Serial upgrade of operating system firmware
procedure
To perform a serial upgrade of the switch operating system firmware image, usually named
HP_10G_100.bin: