Medical Archive Solutions User Guide

203
HP Medical Archive
Server Manager Operation
the installation disks. The server name used in that file is reported by
Server Manager as the Host Name.
IP Addresses
The server’s operating system networking service is used to report the
IP addresses assigned to the network interface(s). Most servers have
only one address; however, if multiple adapters/addresses are avail-
able, all are reported.
Prompt Line
At the very bottom of the display is a prompt line, providing guidance
on what actions you can take. This typically states: “Use tab to select
the button, and enter to activate it.” See “Control Buttons” on page 202
for more on using the buttons.
Using the Interface
Display Updates
The display of service states is updated on a timed poll, every ten
seconds. If the core application of the Server Manager detects an event,
an asynchronous update is possible.
Keyboard Input
The interface only supports use of the command buttons shown in the
bottom left of the display. These are selected and activated using the
<Tab> and <Enter> keys. A confirmation is required for all actions.
Response Time
Note that input from the keyboard is registered with the application
on a polling cycle, which means that there may be a delay of a few
seconds before your keystroke is shown on the display. Keystrokes are
buffered and queued.
Ensure that you see the result of a <Tab> keystroke before pressing the
<Enter> key to activate the selection. Pressing <Tab> repeatedly while