HP 1405 Switch Series Installation and Getting Started Guide (May 2013)

2-7
Installing the HP 1405 Switches
Installation Procedures
Figure 2-3. Wall mounting the switch
Horizontal Surface Mounting
The switch comes with rubber feet in the accessory kit that can be used to
help keep the switch from sliding on the surface. Attach the rubber feet to the
four corners on the bottom of the switch within the raised circles.
Place the switch on a table or other stable uncluttered horizontal surface. You
may want to secure the networking cables and switch power cord to the table
leg or other part of the surface structure to help prevent tripping over the
cords.
Caution Ensure the air flow is not restricted around the switch.
Figure 2-4. Horizontal surface mounting
Wall
Tapping screws
RJ-45 Ports
Wall anchors