Data Center Fabric Manager Enterprise User Manual - Supporting DCFM 10.3.x (53-1001357-01, October 2009)

410 DCFM Enterprise User Manual

53-1001357-01

Disabling a CEE port or LAG

If you select multiple switches or multiple ports and LAGs from two or more switches, both the

Enable button and the Disable button are disabled.

1. Select Configure > CEE Switch > CEE from the menu bar.

The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and

functions.

2. Select one or more CEE ports or link aggregation groups (LAGs) that you want to disable.

NOTE

All selected LAGs must be in the same state (enabled or disabled); otherwise, both the Enable

and Disable buttons are disabled.

3. Click Disable.

4. Click OK.

The CEE Confirmation and Status dialog box displays.

5. Review the changes carefully before you accept them.

6. Click Start to apply the changes, or click Close to abort the operation.

The selected CEE port or LAG is disabled for CEE configuration. (The Status column in the CEE

Configuration dialog reflects the state change).

Deleting a LAG

You can only delete a link aggregation group (LAG) that is selected from a single switch. If you select

multiple switches or multiple LAGs from two or more switches, the Delete button is disabled.

1. Select Configure > CEE Switch > CEE from the menu bar.

The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and

functions.

2. Select one or more LAGs that you want to delete from the Products/Ports table.

3. Click Delete.

4. Click OK.

The CEE Confirmation and Status dialog box displays.

5. Review the changes carefully before you accept them.

6. Click Start to apply the changes, or click Close to abort the operation.

The LAG is removed from the Products/Ports list and any of the LAG members display without

the LAG containment.