Data Center Fabric Manager Professional Plus User Manual - Supporting DCFM 10.3.x (53-1001356-01, October 2009)

102 DCFM Professional Plus User Manual
53-1001356-01
Restoring data to a new server
3
Restoring data to a new server
If your Management application server fails and you must recover information to a new server,
complete the following steps.
1. Restore the data (Refer to “Restoring data” on page 101 for complete instructions).
2. Configure an explicit server IP address (Refer to “Configuring an explicit server IP address” on
page 126 for complete instructions).
Display
You can reset the display to the default settings.
Resetting your display
You can reset your system to display the default display settings. Note that returning to current
settings after a reset may require configuring each global fabric or group setting individually. The
following table (Table 21) details the settings that change with reset and the associated default
state.
To reset the Management application to the default display and view settings, complete the
following steps.
1. Select SAN > Options.
The Options dialog box displays.
2. Select Display in the Category list.
3. Click Reset Display.
4. Click Yes on the reset confirmation message.
The display and view settings are immediately reset to the default display settings (as detailed
in the “Display Settings” table).
5. Click Apply or OK to save your work.
TABLE 21 Display Settings
Settings Default State
Show port Disabled.
Show connected end device Set to Hide All.
Map Layout Set to default for Groups.
Line Types Set to default for Groups.
Port Display Set to Attached Ports only.
Map Flyovers Set to include the following properties:
• Product Display—Name, Device Type, WWN, IP Address, and Domain ID.
• Connection Display—Name (port), Address, Node WWN, Port WWN, and Port #.
Product List Set to only display basic property list.
Table Column Order Set to default for open system.