Data Center Fabric Manager Professional Plus User Manual - Supporting DCFM 10.3.x (53-1001356-01, October 2009)

302 DCFM Professional Plus User Manual
53-1001356-01
Deleting a Top Talker monitor
8
5. Click OK on the Top talker Selector dialog box.
Top Talker is enabled on the selected port.
6. Select the number of Top Talkers (1 through 20) to display from the Display list.
7. Select how often you want the Top Talker to refresh (10, 20, 30, 40, or 50 seconds, or 1
minute) from the Refresh Interval list.
8. Select whether you want to monitor the receive (Rx) flow or the transmit (Tx) flow for the port
from the Flow list.
9. Click Apply.
The top 20 conversations display in the Current Top Talkers table. The Top Talkers Summary
table displays all Top Talkers that occurred since the Top Talkers dialog box was opened
(displays a maximum of 360). When the maximum is reached, the oldest Top Talker drops as a
new one occurs.
The F_port mode Top Talker provides the following details:
• Rx Ave (MB/sec) or Tx Ave (MB/sec)
• Last Occurred
• Occurrences
• SID
• Source Name
• Source Switch/Port
• DID
• Destination Name
• Destination Switch/Port
• Port Speed
• % Utilization
10. Click the minimize button to hide this dialog box when it is not needed.
Deleting a Top Talker monitor
To delete a Top Talker monitor, complete the following steps.
1. Select the dialog box of the Top Talker monitor you want to delete.
2. Click Close.
3. Click Yes on the ‘do you want to delete this monitor’ message.
Pausing a Top Talker monitor
To pause a Top Talker monitor, complete the following steps.
1. Select the dialog box of the Top Talker monitor you want to pause.
2. Click Pause.