Data Center Fabric Manager Professional Plus User Manual - Supporting DCFM 10.3.x (53-1001356-01, October 2009)

304 DCFM Professional Plus User Manual
53-1001356-01
Editing a threshold policy
8
11. Click OK on the New Threshold Policy dialog box.
The threshold policy displays in the Available Threshold Policies table with an added icon ( ).
To assign a threshold policy to a fabric or device, refer to “Assigning a threshold policy” on
page 306.
12. Click OK on the Set Threshold Policies dialog box.
The Confirm Threshold Changes dialog box displays.
13. Make the threshold changes by selecting one of the following options:
• To only add new thresholds, select the Keep currently set thresholds and only add new
thresholds check box.
• To overwrite all existing thresholds on all fabrics and devices, select the Overwrite all
thresholds currently set on all switches check box.
14. Click OK on the Confirm Threshold Changes dialog box.
Editing a threshold policy
To edit a threshold policy, complete the following steps.
1. Select Monitor > Performance > Configure Thresholds.
The Set Threshold Policies dialog box displays.
2. Select the threshold policy you want to edit in the Selected Thresholds table.
3. Click Edit.
The Edit Threshold Policy dialog box displays.
4. Change the policy type from the Policy Type list.
5. Select a measure from the Measure list.
You cannot add the same measure more than once. If you try to add another threshold with the
same measure, the new values overwrite the older threshold values in the Selected Thresholds
table.
6. Enter a percentage for the high boundary in the High Boundary field.
7. (Fabric OS only) Enter a percentage for the low boundary in the Low Boundary field.
8. (Fabric OS only) Enter a percentage for the buffer in the Buffer Size field.
9. Click the right arrow button to move the threshold to the Selected Thresholds table.
If an error is detected, a message displays informing you to enter a valid value. Click OK to
close this message. Fix any errors and repeat step 9.
10. Repeat steps 5 through 9 for each measure that you want to add to the policy.
11. Click OK on the Edit Threshold Policy dialog box.
The threshold policy displays in the Available Threshold Policies table with a modified icon
( ). To assign a threshold policy to a fabric or device, refer to “Assigning a threshold policy” on
page 306.