Data Center Fabric Manager Professional Plus User Manual - Supporting DCFM 10.3.x (53-1001356-01, October 2009)

DCFM Professional Plus User Manual 385
53-1001356-01
Editing a LAG
13
3. Click Edit.
The Edit Port dialog box displays.
FIGURE 110 Edit Port dialog box
4. Modify the following CEE Port parameters as required:
• Status - Enable or Disable. You must enable the LAG to use the CEE functionality.
• Interface Mode - None or L2.
• L2 Mode - This is enabled if you select L2 as the Interface Mode. You cannot change the
Interface Mode to None if it is set to L2 and the port is assigned to a VLAN.
5. When you have finished configuring the policies, apply the settings to the CEE port.
6. Click OK when you have finished modifying the CEE port parameters.
The CEE Confirmation and Status dialog box displays.
7. Review the changes carefully before you accept them.
8. Click Start to apply the changes, or click Close to abort the operation.
Editing a LAG
Use the following procedure to change members and policies in a link aggregation group (LAG).
1. Select Configure > CEE Switch > CEE from the menu bar.
The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and
functions.
2. Select the link aggregation group (LAG) from the Products/Ports table.