Data Center Fabric Manager Professional Plus User Manual - Supporting DCFM 10.3.x (53-1001356-01, October 2009)

406 DCFM Professional Plus User Manual

53-1001356-01

Adding an ACL to a switch

FIGURE 120 Access Control List dialog box

4. Click Add and select Standard or Extended from the Add list.

The Add Extended Access Control List includes all the Standard ACL features plus two

additional features: Destination and Ether Type. The ACL parameters are described below.

FIGURE 121 Add Extended Access Control List dialog box

5. Configure the following Access Control List parameters.

NOTE

You cannot duplicate Action and Source parameters in an existing Standard ACL. You cannot

duplicate Action, Source, Destination, and Ether Type parameters in an existing Extended ACL.

• Sequence - The sequence number that tracks all the ACL entities defined globally in the

system. If you assign a Sequence number that is the same as an existing ACL Entity, an

overwrite warning displays. After the overwrite operation, the system again checks for

duplicates, then it creates the new ACL entity.