Data Center Fabric Manager Professional Plus User Manual - Supporting DCFM 10.3.x (53-1001356-01, October 2009)

438 DCFM Professional Plus User Manual

53-1001356-01

Viewing and editing group properties

To view encryption group properties, complete the following steps.

1. Select Configure > Encryption.

The Encryption Center dialog box displays.

2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu

bar.

The encryption groups display in the Encryption Devices table.

3. Select a group from the Encryption Devices table, and select Group > Properties from the

menu bar, or right-click the group and select Properties.

The Encryption Group Properties dialog box, shown in Figure 132, has six tabs which are

defined in this section:

• “General tab” on page 439

• “Members tab” on page 439

• “Security tab” on page 442

• “HA Clusters tab” on page 443

• “Engine Operations tab” on page 443

• “Link Keys tab” on page 444

• “Tape Pools tab” on page 445

NOTE

The Link Keys tab appears only if the key vault type is NetApp LKM.

FIGURE 133 Encryption Group Properties dialog box