Read Me First for zl Switch v2 Modules K.15.04 or greater

View or download the manual set

For a complete set of manuals for your HP product installation, software features, and configuration information,

go to the HP Web site, www.hp.com/networking/support

Saving the configuration after installing or exchanging a module

The following cases automatically result in a change to the running-configuration on your switch:

■ If you replace a module with another module of a different type and then reboot the switch

■ If you install a module in a slot that has not previously been used (including when you install

a module and apply power to the switch for the first time)

If you want to save such changes to permanent memory (startup-configuration), use the write

memory command in the switch console. This causes the switch to use the new hardware configu-

ration for subsequent reboots. (The switch always reboots from the startup-configuration.)

If you do not save the hardware changes to the startup-configuration, you will be prompted with the

following message the next time you use the reboot or reload commands:

Do you want to save the current configuration [y/n]?

For more information on switch memory, including the startup-config and running-config memories,

refer to the Management and Configuration Guide.

Part Number: 5998-1315

February 2011

Printed in Singapore

*5998-1315*

Development Company, L.P.

The Information contained herein is

subject to change without notice.

v2-zlModules-ReadMe-Jan2011-59981315.fm Page 2 Friday, January 14, 2011 7:46 AM