xl Modules Installation Guide 2007-12

ProCurve Switch xl Modules

Features

• Downlink Ports—This LED is associated with the Locate Ports button

and comes on when the button is pressed once.

• Uplink Network Ports—This LED is associated with the Locate Ports

button and comes on when the button is pressed for the second time.

■ Module Ready LED—This LED comes on after the module completes the

boot up and self test processes and indicates the module is up and running.

■ Mode (selected on switch)—These LEDs operate in conjunction with the

Mode Select button on the switch chassis to show port activity, duplex

mode and link speed. For example, if you have selected “Act” with the

Mode Select button on the chassis, then the two Mode LEDs on the module

(Downlink and Uplink) will blink if there is activity on those ports. For

more information refer to LEDs on Page 1-6 of the ProCurve Series 5300xl

Switches Installation and Getting Started Guide.

■ Module Activity (10%, 50%, 80%)—These LEDs come on according to the

amount of activity or load the module is experiencing. For example, 10%

indicates that the module has a light load, however, 80% indicates that the

module is nearing work load saturation.

■ Module Fault—This LED (colored orange) comes on when there is an

error condition detected in the module.

Battery Installation Required

WARNING ■ The battery requires special handling at end-of-life. The battery

can explode or cause burns if disassembled, charged, or exposed

to water, fire or high temperature. After replacing the battery,

properly dispose of used battery according to instructions.

■ There is a risk of explosion if the battery is replaced by an

incorrect type. Ensure to replace the battery with the same type.

■ To avoid shorting of battery, remove and properly dispose of

battery before returning a module for repair.

The Access Controller xl and the Wireless Edge Services xl modules ship

without the clock battery installed. You insert the battery before installing the

module into the switch. See the following graphic for instructions.