xl Modules Installation Guide 2007-12

12
ProCurve Switch xl Modules
Installing the Modules
Figure 6. Installing a Module
Figure 7. Tighten module retaining screws
For best results, push
simultaneously near both
screws.
“Low-force” connector.
High insertion force is not
needed and should not be
used.
1. Insert module into the
guides and slide it in until it is
fully inserted.
The module is fully inserted when
the module bulkhead is contacting,
or very close to contacting
the face of the switch.
2. Then tighten the retaining
screws on the module until they are
secure, but do not overtighten
them.