2424m Gigabit Stacking Module Installation Guide 1999-03
6
Installing the Module
3. Install the Module
1. Use a Torx T-10 or flat-bladed screwdriver to unscrew the screws in the
module slot cover plate in the back of the Switch 2424M. Then remove the
cover plate and store it for possible future use.
2. Hold the module by its bulkhead, taking care not to touch the metal
connectors or components on the board. Orient the module as shown in
the illustration below.
3. Rotate the lever handle fully outward, and then insert the module into the
slot guides and slide it into the slot until it stops.
4. Make sure the two retaining screws are aligned with the holes in the switch,
then rotate the lever handle inward as far as it will go to pull the module
into the switch connectors. The module bulkhead should be in contact with
the face of the switch.
rotate the handle fully
outward before
installing the module
slot guides
rotate the handle
fully inward
JRUGERRN3DJH7KXUVGD\0DUFK$0