2424m Gigabit Stacking Module Installation Guide 1999-03
11
Installing the Module
7. Customize the Port Configuration (Optional)
If the module slot in the Switch 2424M was empty the last time the switch was
either rebooted or reset (or the power to the switch was cycled), then the
module will use preconfigured default parameter values that will work for
most networks.
The default port configuration for the module is:
■ Ports Enabled: Yes
■ Mode:
• Gigabit-SX and Gigabit-LX Transceivers — 1000FDx (1000 Mbps, Full
Duplex)
• Gigabit Stacking Transceiver — Auto (auto negotiates flow control if
flow control is enabled for the port)
■ Trunk (port trunking): None
■ Switch Mesh: Not a member
■ Broadcast Limit: 0 (no broadcast limiting)
■ Flow Control: Disabled
■ Spanning Tree: Disabled
■ IGMP: Disabled
■ Traffic Filters: None (the switch performs its filtering and forwarding
only according to standard address table operation)
If necessary, configure the port(s) in the module by using the switch console
or the web browser interface. For more information, see the Management and
Configuration Guide shipped with the switch, and the online Help provided
in the console and web browser interface.
If the default port configuration listed above is acceptable for your network,
then skip this process.
JRUGERRN3DJH7KXUVGD\0DUFK$0