Installation Guide for fl Modules 2007-02

ProCurve Switch fl Modules

To perform a controlled shutdown on a management or fabric module, and

cause the redundant module to take over, enter the following command:

ProCurve 8100fl# halt <slot>

You can also perform a controlled shutdown on a management or fabric

module and cause the redundant module to take over, by entering the

following command:

ProCurve 8100fl# power down <slot>

Note To display a list of the slot numbers of all installed modules, type ? after the

command; for example, halt ? or power down ?.

Configuration Changes to Management Module

In normal operation, whenever you make configuration changes to the

primary management module, the changes are copied to the redundant

management module’s configuration file. In this way, if the primary

management module fails, the redundant module has all the configuration

information necessary to take over as the primary management module.