Installation Guide for fl Modules 2007-02

ProCurve Switch fl Modules
Installing Modules
6.
1. Pull out upper ejector
lever to hold it in
unlocked position.
Note
7.
Tighten the captive screw on each ejector by hand and seat with a screw
driver to keep the module from being removed accidentally. Do not
overtighten the captive screws. (You can tighten the thumb screws with
a P2 Phillips screwdriver to eliminate the possibility of casual removal by
unauthorized personnel.)
2. Install switch fabric
modules in either of
the two center slots.
3. Rotate ejectors to
secure and tighten
captive screws.
Switch Fabric Module
Metal Plate
Module Guides
The module must be fully seated and the ejectors must be fully locked
(vertical) before the captive screws will align properly. Also, by fully
seating the module, you ensure proper contact of the module with the
backplane, which is necessary for optimal performance.
Repeat steps 1 to 6 to install a second switch fabric module to provide full
(100%) redundancy in case of failure of the primary switch fabric module.
12