Installation Guide for fl Modules 2007-02

ProCurve Switch fl Modules

Installing Modules

6. Tighten the captive screw on each ejector by hand and seat with a screw

driver to keep the module from being removed accidentally. Do not

overtighten the captive screws. (You can tighten the thumb screws with

a P2 Phillips screwdriver to eliminate the possibility of casual removal by

unauthorized personnel.)

2. Install management

modules on either side

of the two central slots.

3. Push in ejectors in to

secure and tighten

captive screws.

1. Pull out upper ejector

lever to hold it in

unlocked position.

Management

Module

Metal Plate

Module Guides

Note A management module must be fully seated and the ejectors must be fully

locked (vertical) before the captive screws will align properly. Also, by

fully seating the module, you ensure proper contact of the module with

the backplane, which is necessary for optimal performance.

7. Repeat steps 1 through 6 if you are installing a second, redundant

management module.