Brocade Converged Enhanced Ethernet Administrator's Guide v6.1.2_cee (53-1001258-01, June 2009)

130 Converged Enhanced Ethernet Administrator’s Guide
53-1001258-01
FCoE minimum configuration
9
FCoE minimum configuration
The following example shows the minimum configuration steps required to run FCoE on the
Brocade 8000 CEE switch.
Step 1. Configure a CEE interface as a Layer 2 switch port:
switch:admin> cmsh
switch#enable
switch#config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#interface tengigabitethernet 0/0
switch(config-if)#switchport
switch(config-if)#no shutdown
switch(config-if)#exit
switch(config)#exit
switch#show ip interface brief
Interface IP-Address Status Protocol
TenGigabitEthernet 0/0 unassigned up up
TenGigabitEthernet 0/1 unassigned administratively down down
.
.
.
TenGigabitEthernet 0/23 unassigned administratively down down
switch#
Step 2. Create an FCoE VLAN and add an interface to it:
switch:admin>cmsh
switch#enable
switch#config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#vlan classifier rule 1 proto fcoe encap ethv2
switch(config)#vlan classifier group 1 add rule 1
switch(config)#interface vlan 5
switch(conf-if-vl-5 )#fcf forward
switch(conf-if-vl-5 )#interface tengigabitethernet 0/0
switch(config-if-te-0/0)#switchport
switch(config-if-te-0/0)#switchport mode access
switch(config-if-te-0/0)#vlan classifier activate group 1 vlan 5
switch(config-if-te-0/0)#qos flowcontrol pfc 3 tx on rx on
switch(config-if-te-0/0)#no shutdown
switch(config-if-te-0/0)#exit
switch(config)#exit
switch#exit
Step 3: Create a CEE Map to carry LAN and SAN traffic and apply it to an interface:
switch:admin>cmsh
switch#enable
switch#config t
switch(config)#cee-map default
switch(conf-cee-map)#priority-group-table 1 weight 40 pfc
switch(conf-cee-map)#priority-group-table 2 weight 60
switch(conf-cee-map)#priority-table 2 2 2 1 2 2 2 2
switch(conf-cee-map)#interface tengigabitethernet 0/0
switch(conf-if-te-0/0)#cee default
switch#end
switch#exit