Brocade Converged Enhanced Ethernet Administrator's Guide v6.1.2_cee (53-1001258-01, June 2009)

Converged Enhanced Ethernet Administrator’s Guide 75
53-1001258-01
LACP configuration procedures
5
Configuring the LACP timeout period on a CEE interface
The LACP timeout period indicates how long LACP waits before timing out the neighboring device.
The short timeout period is 3 seconds and the long timeout period is 90 seconds. The default is
long.
To configure the LACP timeout period on a CEE interface, perform the following steps from
Privileged EXEC mode:
Clearing LACP counter statistics
To clear LACP counter statistics, perform the following tasks from Privileged EXEC mode:
Step Task Command
1. Enter global configuration mode. switch#config t
Enter configuration commands, one per
line. End with CNTL/Z.
switch(config)#
2. Specify the CEE interface (interface 0/1 is used
in this example).
switch(config)#interface
tengigabitethernet 0/1
switch(conf-if-te-0/1)#
3. Enable the CEE interface. switch(conf-if-te-0/1)#no shutdown
switch(conf-if-te-0/1)#
4. Specify the LACP timeout period for the CEE
interface:
• long—LACP long timeout
• short—LACP short timeout
switch(conf-if-te-0/1)#lacp timeout
{long | short}
5. Display the LACP configuration for the specified
port.
switch(conf-if-te-0/1)#do show port
port-channel tengigabitethernet
Slot/Port
Task Command
Clear the LACP counter statistics for the specified
LAG group number.
switch#clear lacp 1-63 counters
Clear the LACP counter statistics for all LAG
groups.
switch#clear lacp counters