Comware CLI Commands in Provision Software 2013/06

display ipv6 routing-table protocol
Related ProVisionComware
show ipv6 route {connected | static | ospf3}display ipv6 routing-table protocol
NOTE: This command is not supported for OSPFv3 on the HP 2920 Series switches.
Displays routing information for a specified routing protocol. The routing protocol specified may
be static, direct or ospfv3.
HP Switch# display ipv6 routing-table protocol direct
Routing Table: n/a
Destinations: 1 Routes: 1
Destination : ::1/128 Protocol : Direct
NextHop : ::1 Preference : 0
Interface : InLoop0 Cost : 1
HP Switch# display ipv6 routing-table protocol direct verbose
Routing Table: n/a
Destinations: 1 Routes: 1
Destination : ::1 PrefixLength : 128
NextHop : ::1 Preference : 0
RelayNextHop : n/a Tag : n/a
Neighbor : n/a Process ID : n/a
Interface : InLoopBack0 Protocol : Direct
State : Active Adv Cost : 1
Tunnel ID : n/a Label : n/a
Age : 37221sec
Example of Related ProVision Software Command Output.
HP Switch# show ipv6 route static
IPv6 Route Entries
Destination : 2620:a::/64
Gateway : 2620:b::22:1
Type : static Sub-Type : NA Distance : 1 Metric : 1
Destination : 2620:c::/64
Gateway : 2620:e::55:2
Type : static Sub-Type : NA Distance : 1 Metric : 1
Operating Notes
For more information, refer to the latest IPv6 Configuration Guide for your switch.
Minimum Software Version: 15.10.
130 Display Commands