Comware CLI Commands in Provision Software 2013/06

display loopback-detection
Related ProVisionComware
No equivalent ProVision software commanddisplay loopback-detection
Displays the operating status of the loopback detection function. Field Descriptions
HP Switch(config)# display loopback-detection
Loopback-detection is running.
Detection interval is 30 second(s).
Action mode: None
Loopback-detection is enabled on the following VLAN(s):
1, 20, 315, 1001, 2008, 2010-2015, 2026
Loopback is detected on the following interface(s):
1
2
3
10
Field Descriptions
Detection Interval: Loopback detection interval in seconds.
Action Mode: The loopback detection action:
• None—When detecting a looped port, the system prints log information and sends trap
messages.
• Shutdown—When detecting a looped port, the system prints log information, sends trap
messages, and shuts down the port.
There is no related ProVision command.
154 Display Commands