Comware CLI Commands in Provision Software 2013/06

display multicast routing-table static
Related ProVisionComware
show ip pim rpf-overridedisplay multicast routing-table static
NOTE: This command is not supported on the HP 2920 Series switches.
Displays the information about multicast static routes.
HP Switch# display multicast routing-table static
Multicast Routing Table of VPN-Instance: n/a
Routes : n/a
Mroute 10.10.0.0/16
Interface = n/a RPF Neighbor = 2.2.2.2
Matched routing protocol = <none>,Route-policy = <none>
Preference = n/a, Order = n/a
Running Configuration = rpf-override 10.10.10.10/32 10.10.10.1
Field Descriptions
Multicast Routing Table of VPN-Instance: public net: Multicast routing table for the public network
Mroute: Multicast route source address and its mask length
Interface: Outgoing interface to the multicast source
RPF Neighbor: IP address of the RPF neighbor through which the multicast source is reachable
Route-policy: Routing policy. The multicast source address of the route should match the routing
policy.
Preference: Route preference
Order: Sequence number of the route
Running Configuration: Command line that configures the multicast static route
Operating Notes
ProVision switches use a different command to define the static multicast routes, The corresponding
config command is displayed in the command. For more information on multicast static routes, see
the "PIM-SM (Sparse Mode)" or the "PIM-DM (Dense Mode) chapters in the latest Multicast and
Routing Guide for your switch.
Example of Related ProVision Software Command Output.
HP Switch(config)# show ip pim rpf-override
Static RPF Override
Multicast Source RPF IP Address
------------------- ---------------
10.1.1.1/32 11.2.2.1
13.1.1.1/32 12.1.1.1
display multicast routing-table static Field Mappings.
ProVision SoftwareComware
n/aMulticast Routing Table of VPN-Instance: public net
n/aMroute
186 Display Commands