Comware CLI Commands in Provision Software 2013/06

display ospfv3
Related ProVisionComware
show ipv6 ospf3display ospfv3
NOTE: This command is not supported on the HP 2920 Series switches.
Displays brief information about OSPFv3.
HP Switch# display ospfv3
Routing Process "OSPFv3 (1)" with ID 3.3.3.3
Graceful restart restarter disabled
Graceful restart helper enabled
Graceful restart helper strict-lsa-checking disabled
Graceful restart interval n/a
SPF schedule delay 5 secs, Hold time between SPFs 10 secs
Minimum LSA interval n/a, Minimum LSA arrival n/a
Number of external LSA 1. These external LSAs' checksum Sum
0x7741
Number of AS-Scoped Unknown LSA 0
Number of LSA originated 4
Number of LSA received 0
Number of areas in this router is 2
Area BACKBONE(0)
Number of interfaces in this area is 1
SPF algorithm executed 0 times
Number of LSA 0. These LSAs' checksum Sum 0x0000
Number of Unknown LSA 0
Area 0.0.0.1
Number of interfaces in this area is 1
SPF algorithm executed 9 times
Number of LSA 2. These LSAs' checksum Sum 0x1A56A
Number of Unknown LSA 0
Example of Related ProVision Software Command Output.
HP Switch# show ipv6 ospf3 general
OSPFv3 General Status
OSPFv3 protocol :enabled
Router ID :10.10.10.80
...
Nonstop forwarding : Enabled
Graceful Restart Interval : 500
Graceful Restart Helper Mode : Enabled
...
Operating Notes
For more information, refer to the latest Management and Configuration Guide for your switch.
Minimum Software Version: 15.10.
200 Display Commands