Comware CLI Commands in Provision Software 2013/06

display ospfv3 area area-id peer verbose
Related ProVisionComware
No equivalent ProVision software commanddisplay ospfv3 area area-id peer verbose
NOTE: This command is not supported on the HP 2920 Series switches.
Displays detailed information about OSPFv3 neighbors for a specified area.
HP Switch(config)# display ospfv3 area 1 peer verbose
Neighbor 3.3.3.3 is Full, interface address FE80::221:F7FF:FE1B:EC80
In the area 0.0.0.1 via interface Vlan-interface2
DR is 3.3.3.3 BDR is 2.2.2.2
Options is 0x000013 (-|R|-|-|E|V6)
Dead timer due in 00:00:34
Neighbor is up for 00:01:44
Database Summary List 0
Link State Request List 0
Link State Retransmission List 0
Graceful restart state: Normal
Field Descriptions
Neighbor: Neighbor ID.
Interface Address: Interface Address
In the area: The area address.
Vlan-interface: Vlan-interface <vid> belongs to area <area>
DR/BDR: Router Id of the Designated Router and Backup Designated Router.
Options: Displays the capabilities.
Dead timer: Indicates when the dead timer is due.
Neighbor up: Neighbor has been up for the indicated time.
Database Summary List: Number of LSAs sent in the DD packet.
Link State Request List: Number of LSAs in the link state request list.
Link State Retransmission List: Number of LSAs in the link state retransmission list.
Graceful restart state: Graceful restart status can be:
• Normal: Normal status
• Helper: The device is a Graceful Restart Helper of the neighbor.
Operating Notes
For more on switch OSPFv3 operation, refer to the "OSPFv3 Routing" chapter in the latest IPv6
Configuration Guide for your switch.
204 Display Commands