Comware CLI Commands in Provision Software 2013/06

display ospfv3 vlink
Related ProVisionComware
show ipv6 ospf3 virtual-link ?display ospfv3 vlink
NOTE: This command is not supported on the HP 2920 Series switches.
Displays OSPFv3 virtual link information.
HP Switch# display ospfv3 vlink
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area :0.0.0.1 via interface Vlan-interface11, instance ID: 0
Local address: 2000:1::1
Remote address: 2001:1:1::1
Transmit Delay is 1 sec, State: P-To-P,
Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Retransmit: 5
Hello due in 00:00:02
Adjacency state :Full
Field Descriptions
Virtual Link: The virtual link name and destination router ID.
Transit area: The VLAN interface ID and transit area.
Instance ID: Instance identity.
Local address: The local router IPv6 address.
Remote address: The remote router IPv6 address.
Transmit Delay: The transmit delay for sending LSAs.
State: The state of the interface, such as P-To-P.
Timer intervals: The configured timer intervals for Hello, Dead, Wait, and Retransmit.
Hello due in: The interval until the next Hello packet is sent.
Adjacency state: The current virtual neighbor adjacency state
Operating Notes
To configure OSPFv3 operation in ProVision software, see the “OSPFv3 Routing” chapter in the
latest IPv6 Configuration Guide for your switch.
Minimum Software Version: 15.08.
Example of Related ProVision Software Command Output.
HP Switch(config)# show ipv6 ospf3 virtual-link
OSPFv3 Virtual Interface Status
Transit AreaID Neighbor Router Interface State
--------------- --------------- ---------------
0.0.0.1 1.1.1.1 P2P
220 Display Commands