Comware CLI Commands in Provision Software 2013/06

display poe device
Related ProVisionComware
show power-over-ethernet briefdisplay poe device
NOTE: This command is not supported on the HP 2920 Series switches.
Displays the mapping between ID, module, and slot of the power sourcing equipment (PSE).
HP Switch# display poe device
PSE ID SlotNo SubSNo PortNum MaxPower(W) State Model
A 1 n/a 24 370 off J9310A
Example of Related ProVision Software Command Output.
HP Switch# show power-over-ethernet brief
Status and Counters - Port Power Status
System Power Status : No redundancy
PoE Power Status : No redundancy
Available: 300 W Used: 0 W Remaining: 300 W
Module A Power
Available: 300 W Used: 5 W Remaining: 295 W
PoE | Power Power Alloc Alloc Actual Configured Detection Power
Port | Enable Priority By Power Power Type Status Class
------ + ------ -------- ----- ----- ------ ----------- ----------- -----
A1 | Yes low usage 17 W 5.0 W Phone1 Delivering 1
A2 | Yes low usage 17 W 0.0 W Searching 0
A3 | Yes low usage 17 W 0.0 W Searching 0
A4 | Yes low usage 17 W 0.0 W Searching 0
A5 | Yes low usage 17 W 0.0 W Searching 0
A6 | Yes low usage 17 W 0.0 W Searching 0
Operating Notes
For more information, refer to the latest Management and Configuration Guide for your switch.
Minimum Software Version: 15.10.
display poe device 237