Comware CLI Commands in Provision Software 2013/06

display poe interface power
Related ProVisionComware
show power-over-ethernet briefdisplay poe interface power
NOTE: This command is not supported on the HP 2920 Series switches.
Displays the PoE power information of the specified port on the switch. If you enter the command
without an argument, the PoE power information about all PoE-capable ports on the switch is
displayed.
HP Switch# display poe interface power
Interface CurPower PeakPower MaxPower PD Description
(W) (W) (W)
1 0.0 0.0 15.4
2 0.0 0.0 15.4
3 0.0 0.0 15.4
4 0.0 0.0 15.4
5 0.0 0.0 15.4
6 0.0 0.0 15.4
7 0.0 0.0 15.4
8 0.0 0.0 15.4
9 0.0 0.0 15.4
10 0.0 0.0 15.4
11 0.0 0.0 15.4
12 0.0 0.0 15.4
13 0.0 0.0 15.4
14 0.0 0.0 15.4
15 0.0 0.0 15.4
16 0.0 0.0 15.4
17 0.0 0.0 15.4
18 0.0 0.0 15.4
19 0.0 0.0 15.4
20 0.0 0.0 15.4
21 0.0 0.0 15.4
22 0.0 0.0 15.4
23 0.0 0.0 15.4
24 0.0 0.0 15.4
--- 0 port(s) on, 0.0 (W) consumed, 0.0 (W) remaining ---
Example of Related ProVision Software Command Output.
HP Switch# show power-over-ethernet brief
Status and Counters - Port Power Status
System Power Status : No redundancy
PoE Power Status : No redundancy
Available: 300 W Used: 0 W Remaining: 300 W
Module A Power
Available: 300 W Used: 5 W Remaining: 295 W
PoE | Power Power Alloc Alloc Actual Configured Detection Power
Port | Enable Priority By Power Power Type Status Class
------ + ------ -------- ----- ----- ------ ----------- ----------- -----
A1 | Yes low usage 17 W 5.0 W Phone1 Delivering 1
A2 | Yes low usage 17 W 0.0 W Searching 0
A3 | Yes low usage 17 W 0.0 W Searching 0
A4 | Yes low usage 17 W 0.0 W Searching 0
A5 | Yes low usage 17 W 0.0 W Searching 0
A6 | Yes low usage 17 W 0.0 W Searching 0
240 Display Commands