Comware CLI Commands in Provision Software 2013/06

display switchover state
Related ProVisionComware
show redundancydisplay switchover state
Displays the backup state of the specified main board. This command displays the backup state
on the AMB or the standby main board (SMB) depending on the slot number specified. The backup
state of the AMB is displayed if no slot number is specified.
HP Switch-8200# display switchover state
Master HA state to slot [0] : Relative backup to slave
HP Switch-8200# display switchover state slot 0
Slave HA State: Receiving realtime data
HP Switch-8200# display switchover state slot 1
Master HA State to Slot [0]: Relative backup to slave
HP Switch-3800# display switchover state
Comware: The corresponding ProVision command is "show redundancy".
Field Descriptions
Master HA State to Slot: Backup state between the active main board (AMB) and the standby main
board (SMB).
Slave HA State: Indicates that the output information is generated by the SMB and describes the
switchover state of the SMB.
Operating Notes
In Comware, either 0 or 1 displays for the slot, depending on which board is active (master or
slave).
For more information about redundancy, see the "Chassis Redundancy (8200zl Switches)" chapter
in the latest Management and Configuration Guide for your switch.
Example of Related ProVision Software Command Output.
HP Switch(config)# show redundancy
Settings
--------
Mgmt Redundancy : Nonstop switching enabled
Rapid Switchover Stale Timer : 0
Statistics
----------
Failovers : 0
Last Failover :
Slot Module Description Status SW Version Boot Image
---- ---------------------------------------- -------- ------------ ----------
MM1 HP J9092A Management Module 8200zl Active K.15.01.000x Primary
MM2 HP J9092A Management Module 8200zl Standby K.15.01.000x Primary
FM1 HP J9093A Fabric Module 8200zl Enabled
FM2 HP J9093A Fabric Module 8200zl Enabled
298 Display Commands