Comware CLI Commands in Provision Software 2013/06

display transceiver alarm interface
Related ProVisionComware
show interface transceiver detaildisplay transceiver alarm interface
Displays the current alarm information of a single or all transceivers.
HP Switch(config)# display transceiver alarm interface g1
G1 transceiver current alarm information:
Rx power low
Field Descriptions
RX loss of signal: Incoming (RX) signal is lost.
TX fault: Transmit (TX) fault
RX power high: Incoming (RX) power level is high.
RX power low: Incoming (RX) power level is low.
TX power high: TX power is high.
TX power low: TX power is low.
TX bias low: TX bias current is low. TX bias high: TX bias current is high.
Temp high: Temperature is high.
Temp low: Temperature is low.
Voltage high: Voltage is high.
Voltage low: Voltage is low.
Transceiver info I/O error: Transceiver information read and write error
Transceiver info checksum error: Transceiver information checksum error
Transceiver type and port configuration mismatch: Transceiver type does not match port
configuration.
Transceiver type not supported by port hardware: Transceiver type is not supported on the port.
RX loss of signal: Incoming (RX) signal is lost.
RX not ready: RX is not ready
RX CDR loss of lock: RX clock cannot be recovered.
TX fault: TX fault
TX not ready: TX is not ready
TX CDR loss of lock: TX clock cannot be recovered.
Module not ready: Module is not ready.
APD supply fault: APD (Avalanche Photo Diode) supply fault
TEC fault: TEC (Thermoelectric Cooler) fault
Wavelength unlocked: Wavelength of optical signal exceeds the manufacturer's tolerance.
RX power high: RX power is high.
RX power low: RX power is low.
TX power high: TX power is high.
TX power low: TX power is low.
TX bias high: TX bias current is high.
TX bias low: TX bias current is low.
302 Display Commands