Comware CLI Commands in Provision Software 2013/06

Temp high: Temperature is high.
Temp low: Temperature is low.
Voltage high: Voltage is high.
Voltage low: Voltage is low.
Transceiver info I/O error: Transceiver information read and write error
Transceiver info checksum error: Transceiver information checksum error
Transceiver type and port configuration mismatch: Transceiver type does not match port
configuration.
Transceiver type not supported by port hardware: Transceiver type is not supported on the port.
Operating Notes
Possible values for HPN and H3C alarms/errors are not the same.
The following alarms/errors are not supported in H3C devices, and they will be displayed in HPN
output, if present:
• WIS local fault
• Receive optical power fault
• PMA/PMD receiver local fault
• PMA/PMD transmitter local fault
• PCS receive local fault
• PCS transmit local fault
• PHY XS receive local fault
• Laser bias current fault
• Laser temperature fault
• Laser output power fault
HPN does not support the following alarms/errors, and they are not displayed in the display
command output:
• RX not ready
• RX CDR loss of lock
• TX not ready
• TX CDR loss of lock
• Module not ready
• APD supply fault
• TEC fault
• Wavelength unlocked
The following values are supported on both HPN and H3C devices:
• Temp high
• Temp low
• Voltage high
• Voltage low
• TX bias high
• TX bias low
display transceiver alarm interface 303