Comware CLI Commands in Provision Software 2013/06

• TX power high
• TX power low
• RX power high
• RX power low
• Transceiver info I/O error
• Transceiver info checksum error
• Transceiver type and port configuration mismatch
• Transceiver type not supported by port hardware
• RX loss of signal
• TX fault
For more information on transceivers, see the "Troubleshooting" chapter in the latest Management
and Configuration Guide for your switch.
Example of Related ProVision Software Command Output.
HP Switch(config)# show interfaces transceiver 23 detail
Transceiver in 23
Interface Index : 24
Type : 10GbE-LR
Model : J8437A
Connector type : SC
Wavelength : Channel #0: 1310nm, #1:0nm, #2:0nm, #3:0nm
Transfer distance : 10000m (SM)
Diagnostic support : DOM
Serial number : ED456SS987
Status
Temperature : 32.754C
TX Bias : 42.700mA
TX Power : 0.5192mW, -2.847dBm
RX Power : 0.0040mW, -23.979dBm
Recent Alarms:
Rx power low alarm
Rx power low warning
Recent errors:
Receive optical power fault
PMA/PMD receiver local fault
PMA/PMD transmitter local fault
PCS receive local fault
PHY XS transmit local fault
Time stamp : Mon Mar 7 16:26:06 2011
display transceiver alarm interface Field Mappings.
ProVision SoftwareComware
n/aRx not ready
n/aRX CDR loss of lock
n/aTX not ready
n/aTX CDR loss of lock
304 Display Commands