Comware CLI Commands in Provision Software 2013/06

display vrrp statistics interface <interface-type> vrid <virtual router-id>
Related ProVisionComware
show vrrp statistics globaldisplay vrrp statistics interface <interface-type> vrid
<virtual router-id>
NOTE: This command is not supported on the HP 2920 Series switches.
Displays statistics about VRRP group(s). If you specify both an interface and a VRRP group, only
the statistics about the specified VRRP group on the interface are displayed. If you only specify an
interface, the statistics about all the VRRP groups on the interface are displayed. If you specify
neither, the statistics about all the VRRP groups on the router are displayed.
HP Switch# display vrrp statistics interface Vlan 3
Interface : Vlan-interface3
VRID : 2
CheckSum Errors : 0 Version Errors : 0
Invalid Type Pkts Rcvd : 0 Advertisement Interval Errors : 0
IP TTL Errors : 0 Auth Failures : n/a
Invalid Auth Type : n/a Auth Type Mismatch : 0
Packet Length Errors : 0 Address List Errors : 0
Become Master : 0 Priority Zero Pkts Rcvd : 0
Adver Rcvd : 0 Priority Zero Pkts Sent : 0
Adver Sent : n/a
Example of Related ProVision Software Command Output.
HP Switch# show vrrp statistics global
VRRP Global Statistics Information
VRRP Enabled : Yes
Protocol Version : 2
Invalid VRID Pkts Rx : 0
Checksum Error Pkts Rx : 0
Bad Version Pkts Rx : 0
For more information, see the latest Multicast and Routing Guide for your switch.
display vrrp statistics interface <interface-type> vrid <virtual router-id> 319