Comware CLI Commands in Provision Software 2013/06

display vrrp verbose
Related ProVisionComware
show vrrpdisplay vrrp verbose
NOTE: This command is not supported on the HP 2920 Series switches.
Displays detailed state information of VRRP group(s). If you specify both an interface and a VRRP
group, only the state information of the specified VRRP group on the interface is displayed. If you
only specify an interface, the state information of all the VRRP groups on the interface is displayed.
If you specify neither, the state information of all the VRRP groups on the router is displayed.
HP Switch# display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 2
Interface Vlan-interface4
VRID : 4 Adver Timer : 1
Admin Status : UP State : Initialize
Config Pri : 144 Running Pri : None
Preempt Mode : YES Delay Time : 0
Auth Type : None Key :
Virtual IP : 14.4.1.1
Virtual MAC : 00005e-000104
Master IP :
Interface Vlan-interface4
VRID : 5 Adver Timer : 1
Admin Status : UP State : Initialize
Config Pri : 154 Running Pri : None
Preempt Mode : YES Delay Time : 0
Auth Type : None Key :
Virtual IP : 14.4.2.1
Virtual MAC : 00005e-000105
Master IP :
VRRP Track Information:
Track Interface: Port23 State : Down Pri
Reduced : n/a
Track Interface: Vlan2 State : Down Pri
Reduced : n/a
Example of Related ProVision Software Command Output.
HP Switch# show vrrp
VRRP Global Statistics Information
VRRP Enabled : Yes
Protocol Version : 2
Invalid VRID Pkts Rx : 0
Checksum Error Pkts Rx : 0
Bad Version Pkts Rx : 0
Virtual Routers Respond To Ping Requests : Yes
VRRP Virtual Router Statistics Information
Vlan ID : 2
320 Display Commands