Comware CLI Commands in Provision Software 2013/06

ProVision Command Location(s)ProVision CommandComware Configuration Command
Access Security GuideSee aaa port-access
authenticator
HP Switch(eth-1)# dot1x
Access Security GuideSee secure modeHP Switch(config)# fips
Access Security GuideSee tacacs-serverHP Switch(config)# hwtacacs
Multicast and Routing GuideSee vlan <vid> ip
igmpComware supports L3 IGMP
HP Switch(vlan-1)# igmp
(snooping and routing) in interface
VLAN context and L2 IGMP
(snooping) in VLAN context.
ProVision IGMP in VLAN context is
similar to Comware’s L3 IGMP.
Multicast and Routing GuideSee vlan <vid> ip igmpHP Switch(config)# igmp-snooping
Multicast and Routing GuideSee vlan <vid> ip igmpHP Switch(vlan-1)# igmp-snooping
Management and Configuration
Guide
ProVision uses just the port number
rather than the “number, sub-number”
Comware format
HP Switch(config)# interface
Management and Configuration
Guide
See ip access-list <acl>
logging
HP Switch(config)# ip access-list logging
Advanced Traffic Configuration GuideSee class or policyHP Switch(config)# ip policy-based-route
Multicast and Routing Guide?See ip icmp redirectHP Switch(config)# ip redirects
Multicast and Routing Guide?See ip icmp unreachableHP Switch(config)# ip unreachables
Management and Configuration
Guide
See ipv6 access-list <acl>
logging
HP Switch(config)# ipv6 access-list
logging
IPv6 Configuration GuideSee ipv6 jumbo ip or tunnel
mtuApplies to both IPv4 and IPv6
HP Switch(config)# ipv6 mtu
Management and Configuration
Guide
See trunkHP Switch(config)# link-aggregation
Advanced Traffic Management GuideSee loop protectHP Switch(config)# loopback-detection
Access Security GuideSee aaa port-access
mac-based
HP Switch(config)# mac-authentication
IPv6 Configuration GuideSee vlan <vid> ipv6 mldHP Switch(config)# mld
IPv6 Configuration GuideSee vlan <vid> ip mldHP Switch(vlan-1)# mld
IPv6 Configuration GuideSee vlan <vid> ipv6 mldHP Switch(config)# mld-snooping
IPv6 Configuration GuideSee vlan <vid> ip mldHP Switch(vlan-1)# mld-snooping
Multicast and Routing GuideSee ip multicastHP Switch(config)# multicast
Multicast and Routing GuideSee router ospfOSPF is enabled
on a VLAN, not a network. In VLAN
HP Switch(config)# ospf
context, use ip ospf. Process IDs
are not supported.
IPv6 Configuration Guidesee router ospf3HP Switch(config)# ospfv3
Access Security GuideAdvanced
Traffic Management Guide
See ip vlan or ip
access-group
HP Switch(eth-1)# packet-filter
Multicast and Routing GuideSee router pimHP Switch(config)# pim
Management and Configuration
Guide
See power-over-ethernetHP Switch(config)# poe-profile
Table of Comware Commands and Associated ProVision Commands 357