Comware CLI Commands in Provision Software 2013/06

display device
Displays the global enable/disable state of GVRP.
Related ProVisionComware
No equivalent ProVision software commanddisplay device
Displays physical modules present in the switch. This command also identifies the status of these
modules, whether they are up/active/standby or failed etc.
HP Switch# display device
SlotNo. Brd Type BrdStatus SubSlotNum SftVer PatchVer
MM1 HP J9092A Management Modul... Standby n/a K.15.09.0000x n/a
MM2 HP J9092A Management Modul... Active n/a K.15.09.0000x n/a
SSM HP J9095A System Support M... Normal n/a K.15.09.0000x n/a
FM1 HP J9093A Fabric Module 82... Enabled n/a K.15.09.0000x n/a
FM2 HP J9093A Fabric Module 82... Enabled n/a K.15.09.0000x n/a
A HP J9536A 20p GT PoE+/2p S... Up n/a K.15.09.0000x n/a
Field Descriptions
Slot No.: Slot number of a card (standalone mode); slot number of a card on the specified member
switch in the format of member ID/slot number (IRF mode)
Brd Type: Hardware type of a card, which can be the following values:
• Specific card model, such as LST1MRPNC1, which is the same as the silkscreen.
• NONE: No card is in the slot.
• UNKNOWN: The card is not supported by the software version and thus cannot start normally.
Brd Status: Card status, which can be the following values:
• Absent: No card is in the slot.
• Master: The card is an AMB.
• Slave: The card is an SMB.
• Normal: The card is an interface card and functions normally.
• Fault: The card has not been booted or an error occurred to the card.
• Off: The card is not powered on.
• Illegal: The card is not supported by the software version and thus cannot start normally.
Subslot Num: Outbound interface in an ARP entry.
Sft Ver: Age timer for a dynamic ARP entry in minutes.
• Specific software version: The software version of the switch.
• NONE: No card is in the slot.
• Mismatched: The software version does not support the card and thus cannot be uploaded.
42 Display Commands