Comware CLI Commands in Provision Software 2013/06

The maximal retransmitting times: Maximum number of attempts for sending an authentication
request to a client.
The maximum 802.1X user resource number per slot: Maximum number of concurrent 802.1X
user per card.
Total current used 802.1X resource number: Total number of online 802.1X users.
GigabitEthernet3/0/1 is link-up: Status of the port. In this example, GigabitEthernet 3/0/1 is up.
802.1X protocol is disabled: Specifies whether 802.1X is enabled on the port.
Handshake is disabled: Specifies whether handshake is enabled on the port.
Handshake secure is disabled: Specifies whether handshake security is enabled on the port.
802.1X unicast-trigger is disabled: Specifies whether unicast trigger is enabled on the port.
Periodic reauthentication is disabled: Specifies whether periodic online user reauthentication is
enabled on the port.
The port is an authenticator: Role of the port.
Authenticate Mode is Auto: Authorization state of the port.
Port Control Type is Mac-based: Access control method of the port.
802.1X Multicast-trigger is enabled: Specifies whether the 802.1X multicasttrigger function is
enabled.
Mandatory authentication domain: Mandatory authentication domain on the port.
Guest VLAN: 802.1X guest VLAN configured on the port. NOT configured is displayed if no guest
VLAN is configured.
Auth-fail VLAN: Auth-Fail VLAN configured on the port. NOT configured is displayed if no Auth-Fail
VLAN is configured.
Max number of on-line users: Maximum number of concurrent 802.1X users on the port.
EAPOL Packet: Number of sent (Tx) and received (Rx) EAPOL packets.
Sent EAP Request/Identity Packets: Number of sent EAP-Request/Identity packets.
EAP Request/Challenge Packets: Number of sent EAP-Request/Challenge packets.
EAP Success Packets: Number of sent EAP Success packets.
Fail Packets: Number of sent EAP-Failure packets.
Received EAPOL Start Packets: Number of received EAPOL-Start packets.
EAPOL LogOff Packets: Number of received EAPOL-LogOff packets.
EAP Response/Identity Packets: Number of received EAP-Response/Identity packets.
EAP Response/Challenge Packets: Number of received EAP-Response/Challenge packets.
Error Packets: Number of received error packets.
Controlled User(s) amount: Number of authenticated users on the port.
Operating Notes
For more on switch 802.1X operation, refer to the "Configuring Port-based and User-based Access
Control (802.1X)" chapter in the latest Access Security Guide for your switch.
Example of Related ProVision Software Command Output.
HP Switch(config)# show port-access authenticator config
Port Access Authenticator Configuration
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
68 Display Commands