Comware CLI Commands in Provision Software 2013/06

display igmp group
Related ProVisionComware
show ip igmp groupsdisplay igmp group
Displays IGMP group address, uptime, and expiry information. If no IGMP groups are detected,
returns the system prompt.
HP Switch# display igmp group
Total 1 IGMP Group(s).
Interface group report information
Vlan-interface1(15.255.134.111):
Total 1 IGMP Group reported
Group Address Last Reporter UpTime Expires
10.255.215.190 10.125.103.197 00:04:22 00:03:38
Field Descriptions
Vlan-interface N : IP address of a VLAN on which IGMP is running.
Group Address: Multicast group address.
Last Reporter: Address of the last host that reported its membership for this multicast group.
UpTime: Length of time since the multicast group was reported.
Expires: Remaining time of the multicast group, where “off” means that the multicast group never
times out.
Operating Notes
To enable IGMP operation in ProVision software, use the following command from the context of
a VLAN on which you want to enable IGMP:
ip igmp
For more on IGMP operation in ProVision software, refer to the chapter titled “Multimedia Traffic
Control with IP Multicast (IGMP)” in the latest Multicast and Routing Guide for your switch.
Minimum Software Version: 15.08.
Example of Related ProVision Software Command Output.
HP Switch# show ip igmp groups
IGMP Group Address Information
VLAN ID Group Address Expires UpTime Last Reporter | Type
------- --------------- ------------- ------------- --------------- + ------
1 10.255.215.190 0h 0m 27s 1h 22m 37s 10.125.103.197 | Filter
IGMP Field Mappings.
ProVision SoftwareComware
VLAN IDVlan-interfaceN
Group AddressGroup Address
ExpiresExpires
UpTimeUptime
Last ReporterLast Reporter
Typen/a
86 Display Commands