Comware CLI Commands in Provision Software 2013/06

display igmp group port-info
Related ProVisionComware
show ip igmp vlan <vid>display igmp group port-info vlan <vid>
Displays Layer 2 port information of IGMP groups, including both dynamic and static Layer 2 port
entries.
HP Switch# display igmp group port-info vlan 5
Total 2 IP Group(s).
Total n/a IP Source(s).
Total n/a MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):5.
Total 2 IP Group(s).
Total n/a IP Source(s).
Total n/a MAC Group(s).
Router port(s):total 2 port(s).
F23 (D)
F24 (D)
IP group(s):the following ip group(s) match to one mac group.
IP group address:239.4.4.4
(0.0.0.0, 239.4.4.4):
Host port(s):total 1 port(s).
F23 (D)
MAC group(s):
MAC group address: n/a
Host port(s):total n/a port(s).
IP group(s):the following ip group(s) match to one mac group.
IP group address:239.14.14.14
(0.0.0.0, 239.14.14.14):
Host port(s):total 1 port(s).
F23 (D)
MAC group(s):
MAC group address: n/a
Host port(s):total n/a port(s).
Field Descriptions
Total 1 IP Group(s): Total number of IP multicast groups.
Total 1 IP Source(s): Total number of IP multicast sources.
Total 1 MAC Group(s): Total number of MAC multicast groups.
Port flags: D-Dynamic port, S-Static port, C-Copy port: Port flags: D for a dynamic port, S for a
static port, and C for a port copied from a (*, G) entry to an (S, G) entry.
Subvlan flags: R-Real VLAN, C-Copy VLAN: Sub-VLAN flags: R for a real egress sub- VLAN under
the current entry, and C for a sub-VLAN copied from a (*, G) entry to an (S, G) entry.
Router port(s): Number of router ports.
Router port unit board: Mask indicating a board with a router port residing on it.
(hh:mm:ss): Remaining time of the aging timer for the dynamic member port or router port:
• In standalone mode, to display the remaining life of a non-aggregation port that does not
belong to the main board, you must specify the number of the slot where the corresponding
card resides by using slot slot-number. This is not required for an aggregation port.
• In IRF mode, to display the remaining life of a non-aggregation port that does not belong to
the main board, you must specify the member ID of the IRF member device and the slot number
90 Display Commands