Comware CLI Commands in Provision Software 2013/06

of the card with chassis chassis-number slot slot-number. For an aggregation port, you do not
need to do this.
Operating Notes
Since ProVision switches do not need anything to be configured globally to enable igmp, no error
message is displayed for a display command if igmp is not enabled. For more information on
IGMP operation, see the "Multimedia Traffic Control with IP Multicast (IGMP)" chapter in the latest
Advanced Traffic Management Guide for your switch.
Example of Related ProVision Software Command Output.
HP Switch(config)# show ip igmp vlan 1
IGMP Service Protocol Info
Total VLANs with IGMP enabled : 30
Current count of multicast groups joined : 20
VLAN ID : 2
VLAN Name : VLAN2
IGMP version : 2
Querier Address : 10.255.128.2
Querier Port : A1
Querier UpTime : 1h 51m 59s
Querier Expiration Time : 2min 5sec
Ports with multicast routers: A1, A5-A6
Active Group Addresses Type Expires Ports Reports Queries
---------------------- ---------- --------------- ---------- ------- -------
226.0.6.7 Filter 2min 5sec A1 10 10
226.0.6.8 Standard 3min 20sec A2 20 20
display igmp group port-info Field Mappings.
ProVision SoftwareComware
n/aTotal 1 IP Group(s)
n/aTotal 1 IP Source(s)
n/aTotal 1 MAC Group(s)
n/aPort Flags
n/aSubvlan Flags
Ports with multicast routersRouter port(s)
Querier Expiration Time(hh:mm:ss)
Active Group AddressesIP group address
n/aMAC group address
n/aAttribute
n/aHost port unit board
n/aHost port(s)
display igmp group port-info 91