A6826A Fibre Channel Mass Storage Adapter Installation Guide, February 2007

Chapter 2
19
2 OpenVMS Installation
This chapter contains OpenVMS installation information for the A6826A Fibre Channel Adapter card and
contains the following sections:
• “Supported Configurations”
• “Superdome Installation”
• “Installation Prerequisites”
• “Driver Software”
• “Install Adapter”
• “Attach Other Devices”
• “Verifying Installation”
• “Additional Configuration Information”
Thank you for purchasing HP I/O Cards
If you are installing an HP I/O card as an add-in device, please review this document before attempting
installation.
If this card was factory installed in your server, you can skip to the Verifying Installation section.
HP welcomes your input. Please email us at: [e-mail] with comments or suggestions on
HP I/O Cards or related documentation.
All product documentation, including a comprehensive Support Guide, Installation Guide, Release Notes,
Support Matrix are available online at: http://docs.hp.com
1. Click on browse by topic.
2. Click on networking and communications.
3. Click on the Fibre Channel product category.
Supported Configurations
Verify compliance with the supported configurations listed in the HP Fibre Channel Host Bus Adapter
Support Matrix, available at: http://www.docs.hp.com/hpux/netcom/index.html#Fibre%20Channel
Superdome Installation
If the adapter is installed in a Superdome system, contact your HP representative for installation assistance.
Adapters in other systems can be installed or replaced by customers or qualified Hewlett-Packard service
representatives.